Polaris 850 MATRYX INDY XC 129 2021

8.24
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3. Reinstall the sway bar link fastener
q
and nut
w
.
Torque nut to specification.
TORQUE
Sway Bar Link Control Arm Fastener:
20 ft-lbs (27 N·m)
4. Reinstall the spindle. See spindle installation
procedure.
5. If the ski assembly was removed, reinstall the ski.
UPPER CONTROL ARM REMOVAL
1. Remove the spindle and ski as an assembly.
2. Remove the sway bar link fastener
q
and nut
w
.
3. Remove the fastener
e
and nut
r
securing the
shock to the lower control arm. Discard the flange
nut.
4. Remove the four flange nuts
t
that secure the pivot
shafts to the bulkhead. Discard the flange nuts.
Remove the upper control arm assembly
y
.
STEERING / SUSPENSIONS