Powtran PI9000 series - Page 115

Chapter 5 Function parameter
109
setting (0 to 1, as
above)
Thousands
digit
DI4 terminal
active status
setting (0 to 1, as
above)
Ten
thousands
digit
DI5 terminal
active status
setting (0 to 1, as
above)
F1.36
DI terminal valid
mode selection 2
Units digit
DI6 terminal active
status setting
0
★
High level active
0
Low level active
1
Tens digit
DI7 terminal
active status
setting (0 to 1, as
above)
Hundreds
digit
DI8 terminal
active status
setting (0 to 1, as
above)
Thousands
digit
DI9 terminal
active status
setting (0 to 1, as
above)
Ten
thousands
digit
DI10 terminal
active status
setting (0 to 1, as
above)
Used to set the digital input terminal active status mode. If high level is selected as
active, it is active when the corresponding DI terminal and COM are connected, disconnected
for inactive. If low level is selected as active, it is inactive when the corresponding DI
terminal and COM are connected, disconnected for active.
F1.37
DI1 delay time
0.0s to 3600.0s
0 . 0s
★
F1.38
DI2 delay time
0.0s to 3600.0s
0 . 0s
★
F1.39
DI3 delay time
0.0s to 3600.0s
0 . 0s
★
Used to set the inverter's delay time for the change of DI terminal status
Currently only DI1, DI2, DI3 terminals can set the delay time function.
F1.40
Define the input
terminal repeat
0: Unrepeatable; 1: repeatable
0
★