Controls and Instruments
56
07106
“SM” = system malfunction
• Stop the vehicle
• Vehicle may no longer be
driven
WARNING
Whenever possible, do not stop the vehicle in
danger zones.
07126
“ES” = Easy Start
• Temporarily, no electronic
starting traction control is
available
WARNING
The vehicle can start moving.
07127
“NS” = Neutral Shift
• Shift transmission to “N”
Neutral
NOTE
Depending on the vehicle type, the
transmission can automatically shift to neutral
in order to protect the mechanical
components of the clutch releasing system
after running a certain amount of time.
07128
“TC” = Transmission Check
• Transmission position cannot
be learned
07129
“CC” = Clutch Check
• Clutch position cannot be
learned
Error messages and the reactions resulting from
these errors can be deleted with the vehicle at a
standstill and the “Ignition OFF”.
* Wait until the display goes out.
* If the display does not go out once the
ignition has been turned “OFF”, set the
battery master switch to the OFF position.
* Switch the ignition back on.
If the error message is still in place, the
transmission has to be repaired. The
transmission is inoperative. The vehicle will
have to be taken to a service point. The error
number(s) must be specified when the service
point is contacted. See paragraph SYSTEM
FAULTS – ERROR MESSAGES in section
TECHNICAL INFORMATION of this manual.
To Next Page
Loading...
