–
For details on the sorting sequence of the pro‐
gram lines see Ä ‘Sorting sequence’
on page 86.
–
The timer program can have a maximum of 99
program lines.
11.3.2.3 Check program lines (
‘Show’
)
‘Menu / Information
è
Timer
è
Set timer
è
Show’
‘Show’
lets you check individual program lines / instructions.
1. Press the
[Clickwheel]
on a program line / instruction.
ð
This display appears:
10:48
Manual
0.25 l/h
monthly
Command 01/05
B0781
on 21st
Above the line Time event (trigger) and possible value
Below the line Action and value, if required
2. Turn the
[Clickwheel]
.
ð
Scroll from instruction to instruction.
The number of the program line or instruction (and the
number of the last program line or instruction) appears at
the top in the dark bar.
3. Pressing the
[Clickwheel]
returns you to
‘Set timer’
.
As the timer software automatically sorts the pro‐
gram lines, the numbers of the program lines can
change if you change something.
The timer software automatically sorts every newly programmed
program line / instruction after completing it (press the
[Clickwheel]
) below the other program lines.
The 1st sorting criterion is the type of time event (trigger) (for the
sequence refer to
Ä Further information on page 81
and
Ä Further
information on page 83
).
Time-dependent program lines are ordered below each other ini‐
tially after the Switching point (2nd sorting criterion)
then after the length of the Cycle (3rd sorting criterion).
The 4th sorting criterion is the type of action (see also the program‐
ming examples at the end of these instructions).
A purely time-controlled timer program will also run in this
sequence.
Sorting sequence
Set up /
‘Menu’
86
To Next Page
Loading...
Need help?
General
