FastTrak TX4650, TX2650 User Manual
32
Windows 2000
New OS Installation
The following details the installation of the FastTrak TX Series RAID Controller
drivers while installing Windows 2000.
1. Start the installation:
• Floppy Install: Boot the computer with the Windows 2000 installation
diskettes.
• CD-ROM Install: Boot from the CD-ROM. Press F6 after the message
“Press F6 if you need to install third party SCSI or RAID driver” appears.
2. When the Windows 2000 Setup window is generated, press S to specify an
Additional Device(s).
3. Insert the FastTrak driver diskette into drive A: and press Enter.
4. Choose Promise FastTrak TX [4650, 2650] (tm) Controller from the list that
appears on screen then press Enter.
5. The Windows 2000 Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include
“Promise FastTrak TX [4650, 2650] (tm) Controller”.
NOTE: If there are any additional devices to be installed, specify them now.
When all devices are specified, continue to the next step.
6. From the Windows 2000 Setup screen, press Enter. Setup will now load all
device files and then continue the Windows 2000 installation.
To Next Page
Loading...
Need help?
General
