Chapter 5: WebPAM
79
4. Click the Locate Drive button.
The Management Window will display the message “Identified started” and the
Status LED for this physical drive will flash rapidly on the SuperSwap enclosure.
If you remove the physical drive, the Status LED stops blinking, the Activity LED
goes dark and WebPAM will report that the physical drive was unplugged. When
you replace the drive, the LEDs will return to normal operation.
If you do not remove the physical drive, click the Located Release button to stop
the Status LED from blinking. For more information, see the SuperSwap User
Manual.
To Next Page
Loading...