Chapter 2: Installation and Setup
15
The first Pegasus unit is Pegasus R4 or (R6), the second is Pegasus R4-2 or
(R6-2), the third is Pegasus R4-3 or (R6-3), and so on.
Your computer lists the Pegasus units by the order in which they are recognized,
not by the cable configuration.
Creating a Disk Array and Logical Drive
To create your disk array and logical drive, look at the Dashboard window, under
System Status, click the Disk Array link. See page 15, Figure 9.
Figure 9. Disk Array link on the Dashboard
The Wizard dialog box opens with three configuration methods. See Figure 10.
To Next Page
Loading...
Need help?
General
