Chapter 3: Management with the Promise Utility
25
Making Controller Settings
To make controller settings:
1. Do one of the following actions,
• Click the Dashboard icon, then click the Controller link.
• From the Device menu, choose Component List.
2. Mouse-over and click the controller, then click the Settings button.
3. Make setting changes as required:
• Enter, change or delete the alias in the Alias field.
• SMART Log – Check the box to enable or uncheck to disable.
• SMART Polling Interval – Enter a value into the field, 1 to 1440
minutes. 1440 minutes = 24 hours
• Enable Coercion – Check the box to enable or uncheck to disable.
• Coercion Method – Choose a method from the dropdown menu:
•GBTruncate
• 10GBTruncate
• GrpRounding
• TableRounding
• Write Back Cache Flush Interval – Enter a value into the field, 1 to 12
seconds.
• Enclosure Polling Interval – 15 to 255 seconds.
4. Click the Save button.
5. Click the X icon to close the settings panel.
Updating Firmware on the Pegasus Unit
Use this function to flash (update) the firmware on the Pegasus. See page 131
for the procedure.
Note
To clear controller statistics, see “Clearing Statistics” on page 21.
To Next Page
Loading...
Need help?
General
