M350 Series User Manual 134
Note: Please not include “https://” or “http://”for the URL address in the Full Filter.
Select from Disable or Enable. The default is Disable.
Select from Key or Full. The default is Key.
Fill in your Key/Full information.
12.9 NAT
This section allows you to set NAT configuration.
When NAT mode isEnable, the router will replace the source private IP address by its Internet
public address for outgoing packets, and replace the destination Internet public address by private
IP address for incoming packets.
When NAT modeis Disable,the router will send the source LAN private IP address for outgoing
packets and allow to receive the destination LAN private IP address for incoming packets.
To Next Page
Loading...
