Proscend M350 Series - OSPF Protocol Configuration

M350 Series User Manual 77
IP Routing >RIP> Interfaces
Item
Description
Interfaces
Mode
Select from Off or On to use or not to use the RIP function in the interface.
Interface
Select from eth1 (WAN Ethernet) or LAN.
Authentication
Select from none or md5 to approve authentication.
Note:
Please offer Key and Key ID when you select md5 to use HMAC-MD5.
Key
The key used for authentication (max length=16).
Key ID
The ID of the key used for authentication (1-255).
Passive
Select from Off or On to send out or not to send out RIP packets on this
interface.
10.4 OSPF
This section allows you to set up OSPF with three sub configurations, including General, Interfaces
and Networks configuration.
(1) General Configuration