Proscend M350 Series - RIP Protocol Configuration

M350 Series User Manual 75
10.3 RIP
This section allows you to configure RIP and select the mode from Disable or Enable. The default is
Disable.
Note:
IP Routing > Policy Route
Item
Description
Mode
The setting is for full network. Select from Disable or Enable.
Settings
Mode
The setting is for the specific network. Select from Disable or Enable.
Name
Set up each name for your running host or network.
Source(IP/MASK)
Fill in the source of a specific IP/MASK from network.
Destination
(IP/MASK)
Fill in the destination of a specific IP/MASK from network.
Gateway
Fill in the gateway address of your router.
Outgoing
Interface
Select the interface from LAN or Ethernet.