Proscend M350 Series - Page 137

M350 Series User Manual 137
Service > SNMP > Community
Item
Description
Mode
Select from Disable or Enable to configure SNMP.
Community
Configure community setting with three options, including # 1, # 2 and #3.
Mode
Select from Disable or Enable.
Name
Name each community.
Access
Select from Read-Only or Read-Write.
For SNMP v3User Configuration, you need to register authentication and allow a receiver that
confirm the packet was not modified in transit. There are three options to set up SNMP v3
Configuration.
Service > SNMP > SNMP v3 User configuration
Item
Description
Mode
Select from Disable or Enable to configure SNMP.
The default is Disable.
Name
Fill in your name.
13.1.2 SNMPv3 User Configuration