Proscend M350 Series User Manual

M350 Series User Manual 151
Mode
Select from Disable or Enable QoS.
Name
The setting can be edited or deleted the existed entries.
Interface
The interface of QoS entry is either WAN Ethernet or LTE and
both options.
Direction
 When selecting Upstream for LAN to WAN traffic, the Port
Begin/End is for public server.
 When selecting Downstream for WAN to LAN traffic, the Port
Begin/End is for public server.
 When selecting Upstream (LAN server) for WAN to LAN traffic,
the Port Begin/End is for LAN server.
 When selecting Downstream (LAN server) for LAN to WAN
traffic, the Port Begin/End is for LAN server.
 Downstream (LAN server) is for LAN to WAN traffic, and the
Port Begin/End is for LAN server.
Min Rate/Max Rate
The unit is kilobits per second. Min Rate guarantee the minimum
bandwidth and Max Rate is the limit bandwidth.
IPv4v6 Address
Choose four types to set address format, including All, Single,
Subnet, and Range.
 All is for none.
 Single is for single IP address.
 Subnet is for IP address with subnet mask bit.
 Range is for the specified range between two IP addresses.
Hint: When [RANGE] is selected, compare the difference from left
to right octet and find out different octet for setting the specified
range of IP address. All other parts after different octet would be
ignored.
Protocol
 All is for none.
 UDP is for User Datagram Protocol.
 TCP is for Transmission Control Protocol.
Port Begin/Port End
the TCP/UDP service port
VLAN follow vid of
 NONE.
 NET1 - NET8.
Note: For NET1 to NET8, make sure the related subnet is
enabled at VLAN->Tag Base. The VLAN ID, vid, will be the VID
field of the related Subnet at VLAN->Tag Base.
COS (Class of Service)
NONE or 0~7. It is class of service for VLAN.
Note: To guarantee minimum bandwidth for assigning each IP, you should select Bandwidth
divided for each IP Address.

Proscend M350 Series Specifications

General

Brand	Proscend
Model	M350 Series
Category	Network Router
Language	English