M350 Series User Manual 179
The VPN Network and VPN Netmask are required fields.
Note: The VPN Network should be network ID (e.g. 192.168.30.1 is invalid setting.)
When PC1 and PC2 communicate each other, the Route Client Networks should be enabled.
And add the LAN information of Open VPN client side, in this case the #1 route will be 10.0.0.0 and
255.255.255.0
Note: The #1 route means the routing information for User 1.
If all settings set up properly, the web UI will show the Apply OK and the Open VPN server status
should be Running. When Open VPN Client mode is connected, the status will show the
information which client is connected, IP address and connected time.
To Next Page
Loading...
