M350 Series User Manual 73
Set up each name for your running host or network.
Fill in the destination of a specific subnet or IP from network.
Fill in the gateway address of your router.
Select the interface from LAN or Ethernet.
Note:
The destination field is required to fill in. The format of destination is IPv4 or IPv6.
The address of gateway or the type of interface can be chosen one or both to fill in the field.
There are two fail situations when you fill in the incorrect type for the field.
(1) Input the invalid format of destination. The interface is shown in Apply fail to notice.
(2) Input the IP address of destination/gateway from IPv4 and IPv6 at the same time. The
interface is shown in Apply fail to notice. You should select either IPv4 or IPv6 as the
address of destination/gateway.
The status tab shows the information from the settings of static route.