3-10
VIBXPERT 11.2010
MENU functions in the tree / list view
• Press the MENU key in the tree / list view (see below):
SKIP / UNSKIP
If a machine is not in operation during a route, you can skip all
measurement tasks planned at this machine. The measurement
tasks that are associated with the highlighted route element and
were not measured are left out. This procedure is reversible.
E
VENT/COMMENT
Enter an event or comment (see p. 3-26).
D
ELETE RESULT
Delete the measurement result for the selected element and all
sub-elements. This procedure cannot be reversed!
S
ET UNMEASURED
Change the status of the associated measurement task to 'not
measured'. All existing results are retained.
R
ESET REFERENCE RPM
The reference rpm of the machine train or the production line
speed is reset and can be measured again.
B
REAK DOWN MULTITASK
All the multi-measurement tasks that are assigned to the highlight-
ed element are broken down into the individual measurement
tasks. This procedure is irreversible!
‘B
REAK NEAR LOCATION’ OFF
The optimized coordination of the measurement tasks for neigh-
boring measurement loations is disabled. The measurements no
longer take place simultaneously.
Measurement - Route
M
E
N
U
Left:
Menu functions
in the Tree view
Right:
Info dialog
For mechanically coded
VIBCODE-locations, the code ring
pattern can be shown.
To Next Page
Loading...
Need help?
General
