2-13
VIBXPERT 11.2010
Display settings, switchoff and additional options
• Click on 'Display' in the 'Device Setup' screen.
C
ONTRAST AND BRIGHTNESS: Click on the respective field and move the
joystick to the right or left. To accept the setting, press the joystick.
S
WITCH BACKLIGHT OFF / AUTO POWER OFF: The display illumination / the
device automatically switches off if no action occurs within the
turn-off time (illumination: 10s ... 1m / device: 6m ... 6h). The
automatic switch off is disabled in the measurement screen /
results screen.
B
ACKGROUND IMAGE: A background image (PNG format) can be dis-
played in the start screen. Four standard images are stored on the
device. Additional images can be loaded onto the device using the
'VIBXPERT utility' tool (see also the appendix, p. 6-8).
S
HOW BATTERY CHARGE: Display the remaining battery charge in percent.
S
PECTRUM: SHOW LINES BELOW LOWER FREQUENCY (F
MIN
): In spectra with a
lower limit frequency of f
min.
> 0 Hz, the lines between 0 Hz and
f
min.
are displayed in the diagram if this option is enabled.
H
IDE CALIBRATION HINT: The message for overdue calibration is not
shown.
• To accept the settings, press MENU and click on 'OK'.
Protective display film
To protect the display against damage, it is covered with a
scratchproof transparent film. The film is easy to remove.
In the VIBXPERT with explosion protection, you must remove this
film before using the measurement device in explosive areas.
Device Setup
Getting started - Basic settings
Attention!
ZOOM
CLR
ENTER
GOTO
PAGE
Protective display film
Display settings
To Next Page
Loading...
Need help?
General
