EasyManuals Logo

PRÜFTECHNIK VIB 5.300 Series User Manual

PRÜFTECHNIK VIB 5.300 Series
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
2-10
VIBXPERT 11.2010
Memory card
A CompactFlash (CF) card with 2 GB memory capacity is installed in
the VIBXPERT as standard (EX ver.: 1 GB). If required, the standard
card can be replaced by a card with greater memory capacity*.
Memory cards that are tested and approved by PRÜFTECHNIK for
use with VIBXPERT, see the document 'Technical Info # CM14',
available on request or on the Internet: www.pruftechnik.com
Backup all data before replacing the card using the 'VIBXPERT
utility' program (P. 6-9, 'Backup')!
The memory card in the VIBXPERT EX device cannot be replaced!
Replacing the memory card
Switch off VIBXPERT.
Carefully remove the cover in the grip. Make sure that the clip of
the cover is not damaged.
Pull out the memory card by the adhesive strip.
Getting started - Memory card
Installation:
Insert the new card in the guide rails of the card slot. Carefully
press in the card up to the endstop. Make sure the card is correctly
oriented! The top of the card should face the back of the device.
Replace the cover on the grip and press it firmly into place.
Make sure that the cover is tightly closed. This guarantees that the
measuring instrument is leakproof (IP65)!
Compartment for memory
card open
Attention!
ZOOM
CLR
ENTER
GOTO
PAGE
Carefully pull out the memory
card by the adhesive strip
Attention!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PRÜFTECHNIK VIB 5.300 Series and is the answer not in the manual?

PRÜFTECHNIK VIB 5.300 Series Specifications

General IconGeneral
BrandPRÜFTECHNIK
ModelVIB 5.300 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals