3-13
VIBXPERT 11.2010
Measurement - Machine template
Measuring with a machine template
A 'Machine template' is used if it is necessary to carry out measure-
ments on machines of the same type. The measurement locations are
always at the same position and the measurement tasks are identical
for each machine. Typical applications are service measurements or
acceptance measurements (production tests) on-site at a machine
manufacturer's. Machine templates are created with the aid of the
OMNITREND PC software.
Select measurement location
Enter machine code
(name, serial number, ...)
The following diagram shows the typical workflow of a measure-
ment:
Select operating mode
Select measurement task,
start measurement
Save measurement result
Next measurement task
Select template
Save
(navigation via tree/
list view or machine
graphic)
To Next Page
Loading...
