SECTION 5
MAINTENANCE
101
5. Once the old Printhead Cartridge has been removed, please refer to the
section titled “Installing Printhead Cartridge”, to reinstall a Printhead or
install a new Printhead Cartridge.
If you plan to replace the Wiper Roller, please do this before installing
the Printhead and priming the system.
See section titled “Service Station Maintenance”.
If you plan to discard the current Printhead, place the Printhead into the
old protective packaging and discard according to local code.
If you plan to reuse the current Printhead, place the Printhead into its
protective packaging and then into a resalable plastic bag along with a
cloth dampened with distilled water.
Reinstall the Ink Revolver Caps [2] to protect the ink system.
To Next Page
Loading...
