SECTION 2
INSTALLING PRINTER
30
Install Printer Software (Driver & Toolbox)
Minimum Comuter System Requirements
For Printer software to operate properly, check that computer system meets minimum requirements :
•
Operating System: Windows 7, Windows 8/8.1, Windows 10. Supports 32- and 64-bit systems.
NOTE: Windows 8, 8.1 and Windows 10 will only work in desktop mode. No Windows 8 or 10 metro apps
will be supported (applications that work ONLY in Windows 8 or 10 environments).
• You must have administrative privileges on computer system.
• Microprocessor: Pentium II, 2 GHz (Optimal: Pentium Dual Core, 2.5 GHz or better)
• System memory: 2 GB minimum, or as recommended for your operating system.
• Free hard-disk space: At least 10 GB.
• Web Browser: Firefox recommended, Chrome, Safari, and Opera also supported.
• USB port (2.0/3.0): (Ports will be identified as “USB” or “Enhanced” in Device Manager)
• Microsoft .Net Framework version 3.5 (for 32-bit systems) or Microsoft .Net Framework version 4
or higher (for 64-bit systems) must be installed.
NOTE for 32-bit System Users: Even if you have a higher .NET Framework version installed,
version 3.5 must also be installed, or the Toolbox will not open.
IMPORTANT: Before installing Printer software (Toolbox and Driver), temporarily disable all antivirus
programs and firewalls. In addition, you must be logged onto system with full administrative privileges
(admin rights). NOTE: If you plan to connect printer via USB, do not plug in USB cable until prompted.
Connecting Printer via USB
Use this procedure for installing the Print Driver for a USB connection. If you plan to connect the printer using a
Network connection, please see section titled “Connecting Printer via Network (Ethernet Connection)”.
1. Disconnect USB cable, if already plugged in.
2. Turn ON and Power-up the Printer. Plug in Printer. Turn ON Main Power Switch. Press Soft-Power
Button to Power-up the Print Engine.
3. Connect USB Flash Drive, supplied with Printer, to USB port on your
computer.
4. Browse the USB Flash Drive.
Locate and open the “MACH 6” folder.
Locate and open the “S Series Driver” folder.
Locate and run WinSetup.exe.
Tip: For best results, Right-click and “run as administrator”.
NOTE: You may want to check the distributor’s website for a more recent version of the “S Series Driver”
for the MACH 6.
5. Install Printer Software. Make sure computer system
meets minimum requirements and you followed other
instructions listed on screen.
Click “Install Printer Software”.
To Next Page
Loading...
