SECTION 3
OPERATING PRINTER
61
4. Install the New Wiper Roller
NOTE: If the new wiper roller has a plastic cover, you must remove the plastic cover before installing
the wiper roller.
Insert the gear-end of the wiper roller into the opening at the non-operator side of the Wiper Motor
Assembly so it engages with the drive gears.
Grasp the new wiper roller near the operator side. Lock the wiper roller into place, onto the Wiper
Motor Assembly, by pushing down and to the right.
5. Verify that the wiper roller is properly installed.
6. Close the Printhead Door.
The printer will run the “Printhead Prime” routine which will also
condition the wiper roller.
7. When Touchscreen shows Online, the process is finished.
System Test
NOTE: These tests should only be performed by authorized service personnel.
System Test allows testing individual, or all Printer
systems listed to check that they are operating
within specifications. It also allows service people
to check the Printer after servicing or replacing
parts, particularly belts.
Tap Menu, then System Test to open the
Password screen. Enter the password and tap
"Submit" to open the System Test screen.
NOTICE:
Prior to running the System Test make sure no
media is loaded in the Printer and there are no
obstructions in the media path.
The Printhead must be installed, and the Printhead
Latch must be shut or the “Sled” and “Printhead”
(lifter) tests will fail.
CAUTION:
To avoid damaging the wiper motor module, do
NOT run “Wiper” test with a dry wiper roller/wiper
motor module. Verify wiper roller is black with
ink, before running “Wiper” test.
The following events hydrate the wiper roller, and
wiper motor module, with ink.
- Printer priming process.
- From Wiper menu, select “Condition Wiper”.
To Next Page
Loading...
