quadient MACH 6 - Install Print Platen & Drip Tray Assembly

SECTION 2
INSTALLING PRINTER
16
1
2
Install Print Platen & Drip Tray Assembly
NOTE: Absorbent material, within new Print Platens and Drip Tray, may have some ink deposits on them.
This is normal. Assemblies are installed and tested during quality control process, then they are removed and
packaged in accessories box.
Select appropriate Platen and Install it into Drip Tray:
• Low Platen [1] (3 dots) is for media such as: heavy paper,
envelopes, card stock, cardboard, chipboard, padded
envelopes.
• High Platen [2] (4 dots) is for thin, flexible media, such as:
sheet paper up to and including 32-pound media.
WARNING: If the High Platen is mistakenly used when
feeding media that is heavier than 32-pound paper, this will
cause media feeding (skewing, jamming) and printing
(scuffing, smudging) issues.
Make sure Platen is properly positioned, and fully inserted onto, both Alignment Pins [A], in Drip Tray,
as shown below.
CAUTION
It is extremely important that you get Platen fully inserted onto both Alignment Pins [A], within Drip
Tray. If not installed properly, media transport issues (skewing, jamming) and or damage to the system
may occur.
A