SECTION 2
INSTALLING PRINTER
18
Attach Media Side Guides and Rear Media Support Guide/Sled
1. Attach Media Side Guides (Inner and Outer)
A. Remove Screws from Mounting Blocks, as shown.
NOTE: There is a button-head screw and a flathead
screw on each block. Keep track of their locations.
B. Position NOTCH (cut-out), located at bottom of Guide, over BAR, as shown.
C. Align holes in Guide with holes in Mounting Block and install screws to secure Guide.
NOTE: Screws are different. Make sure flathead screw [1] is installed into the inner, countersunk,
hole and button-head screw [2] is installed into outer hole in the Guide, as shown below.
Tip: If necessary, Guides can be aligned, so they are perpendicular with each other, by loosening
button-head screw, making adjustment and securing button-head screw.
D. Repeat for other Media Side Guide.
To Next Page
Loading...
