SECTION 2
INSTALLING PRINTER
17
Install Print Platen & Drip Tray Assembly into Printer:
1. Open Ink Tank Door [A].
2. Release, pull out on, Clamshell Latch [B],
to release and raise Clamshell.
3. Insert tabs, at each end of Drip Tray, into frame slots [C] as shown here
Tip: Larger tab, on Drip Tray, faces towards operator side of printer.
4. Verify that the Grounding Spring [D]
makes contact with the bottom of the front
tab on the Drip Tray. Reshape ground
spring as needed.
5. Verify that Print Platen and Drip Tray Assembly are sitting level in the printer, as shown below.
Tip: If front or back of Drip Tray is not
sitting level, check to be sure both tabs
are in slots [C], shown above. If front of
Drip Tray will not drop into front slot
[C], you may have Drip Tray in
backwards. Remove and rotate 180
degrees so the larger tab is at operator
side of printer.
6. Carefully close the Clamshell and Ink Tank Door.
It is extremely important that you get Drip Tray tabs into frame slots [C] and that Platen
is sitting level. If not installed properly, media transport issues (skewing, jamming) and or
damage to the system may occur.
To Next Page
Loading...
