SECTION 6
TROUBLESHOOTING
110
Air in Printhead Nozzle Area:
Air in the printhead nozzles will show as jagged, irregular shaped lines of missing color. Lines are normally wider
than one nozzle.
Possible Solutions:
• Press the “Full Clean Printhead” button, located in the Maintenance Menu. This can help dislodge, purge
and remove air bubbles within the Printhead and Ink Tubes.
• Deprime and Reprime the system.
• Contact Service person to have them inspect the system for possible air leaks (damage to ink tubes or ink
revolver couplings).
• Instead of powering the printer off, when not in use, leave the print engine powered-up, so it can perform
automatic maintenance routines.
NOTE: A similar print pattern, to the one shown above, can be performed using the “Print Ink Channels” button,
located in the Toolbox, “Test Print” drop-down menu.
To Next Page
Loading...
