APPENDIX
130
Appendix E – Extended Rear Media Support Guide
The Extended Rear Media Support Guide (part # 47-116-06) is an optional accessory.
It extends the support range of long media up
to 19” (482.6 mm) for stiff media and up to
22" (558.8 mm) for flexible media.
Included:
(1) Extended Rear Media Support Guide plate
Tools Needed:
Phillips screwdriver
How to Install the Extended Rear Media Support Guide
1. Remove (2) screws [A] securing the original Rear
Media Support Guide/Sled Assembly to the Center
Plate.
2. Remove the Locking Knob [B] to finish removing
the Rear Media Support Guide/Sled Assembly from
the printer.
3. Remove the Locking Knob and (2) screws [C], securing the Sled and Support Nut [D] to the original Rear
Media Support Guide. Be careful not to drop and loose the Support Nut.
To Next Page
Loading...
