SECTION 5
MAINTENANCE
98
Ink Tank Storage
Ink Tank storage should take place, in the original/sealed packaging, under the following conditions:
Storage Temperature Range:
Long Term: 41°F to 113°F (5°C to 45°C)
Short Term: -13°F to 158°F (-25°C to 70°C)
NOTE: Cumulative storage duration below 41°F (5°C) or
above 113°F (45°C) must not exceed 72 hours.
Humidity Range:
5% to 95% Relative Humidity, non-condensing
Atmospheric Pressure Range:
70 kPa to 106 kPa
Electrostatic Discharge:
8 kV air discharges or 4 kV contact discharges*
*When tested in accordance with IEC 61000-4-2
• Store Ink Tanks with contacts (septum seals and QA chip) facing up.
• Exposure to conditions that are not permissible may lead to damage which is not externally visible.
Opened Ink Tanks should be installed and remain in the Printer until they are empty and need to be replaced.
If you find it necessary to remove Ink Tanks from the printer, for an extended period of time, it would be best to
place them in individual, sealed plastic bags. This will help to seal the Ink Tanks and protect people/property from
any ink that may drip from the septum seals.
Ink Tank Disposal
Safely dispose of Ink and Ink Tanks in accordance with local/national regulations.
Clean up spills with soap and water. Abrasive soap is effective in cleaning ink off your hands.
To Next Page
Loading...
