SECTION 5
MAINTENANCE
93
SECTION 5 – Maintenance
General, periodic maintenance is needed to keep Printer in good working order. This section covers how to care for
the Printer and Printer Components (Ink Tanks, Printhead Cartridge, Service Station, etc.). It also covers Ink Tank,
Printhead and Sheet Separator replacement.
Cleaning Printer and Printer Components
PRINTER IS A PRECISION MACHINE. CLEAN REGULARLY TO INSURE MANY
YEARS OF SERVICE. BEFORE PERFORMING ANY MAINTENANCE,
DISCONNECT MACHINE FROM ITS POWER SOURCE!
DO NOT REMOVE SIDE COVERS! HIGH VOLTAGES PRESENT.
Clean Printer regularly to remove accumulated paper dust and ink. Depending on types of media run, paper dust
may accumulate inside Printer and on Transport.
1. Turn Printer OFF and unplug it from power receptacle.
2. Interior (feed table, media transport and Print Engine areas): Use a vacuum with a soft brush attachment or
a can of compressed air to help loosen dust particles.
CAUTION: Be careful around Print Platen & Drip Tray Assembly, as accumulated ink may splash onto
other parts of Printer and cause damage to the system.
3. Exterior (doors, covers and frame): Wipe clean with a lint-free cloth using any standard nonabrasive
household cleaner that does not contain plastic-harming solvents.
NEVER SPRAY OR POUR CLEANERS DIRECTLY ON OR INTO PRINTER.
EXCESS LIQUID COULD HARM ELECTRONIC PARTS. DAMPEN A LINT-FREE
CLOTH WITH THE CLEANER AND APPLY IT TO PARTS TO BE CLEANED.
Cleaning Feed Rollers and Forwarding Rollers
Feed, Forwarding and Transport Rollers can become glazed with paper lint and ink from media.
Clean regularly with a mild abrasive household cleaner on a damp lint-free cloth.
NOTE: Avoid using solvents on Rubber Rollers.
To Next Page
Loading...
