SECTION 3
OPERATING PRINTER
50
Touchscreen Menu Choices and Features
When you touch the “Menu Button” [B] a drop-down list of Menu choices appears with the following selections:
Job, Setup, Test Print, Maintenance, Wiper and System Test.
Touch one of these Menu selections to display the corresponding Menu Feature Buttons [G].
Job Menu
Tap to open the “Media Setup” Menu
Job Menu Buttons provide quick access to common functions needed when printing a Job, such as:
Test Path, Media Setup, Pause, Cancel Job, Stored Jobs
Test Path - Tap to run media through the
Printer, without printing, to check the media
feed set-up.
CAUTION! Before using this feature, you
need to make sure the printer has been
properly setup to separate and feed the media
you are using.
After pressing “Test Path” button the printer
transport will start and media, if present, will be fed
from the feeder section into the print area and though
the system.
A “Stop Path” button will be displayed at this time.
Tap “Stop Path” to stop feeding and transport
process.
If a paper feed error occurs the “Clear Error”
button will appear. Remove media from the
paper path and tap Clear Error button.
Tip: You can use the “Run Path” feature
(Menu, Setup and Run Path) to clear media from
the printer, while in an error state. Do not use this feature if there is a physical jam. Physical jams must be
removed manually. See “Removing Jammed or Misfed Media” for instructions.
To Next Page
Loading...
