SECTION 2
INSTALLING PRINTER
19
2. Attach Rear Media Support Guide/Sled Assembly.
A. Remove Knob [3] (thumb screw and washer) and two Flathead Screws [4] from Mounting
Blocks, as shown below.
.
B. Align Nuts, on Mounting Block, before proceeding.
Bottom of Rear Media Support Guide/Sled Assembly has cut-outs
that must fit over Nuts on Mounting Block.
NOTE: Image shown with Guide turned over so you can see
cut-outs for Nuts.
Align Nuts so a flat side is facing the Feed Rollers, as shown.
C. Position Guide so outer holes in Guide fit over the two rear posts (Allen screws), as shown below.
Then loosely install Knob, (thumbscrew and washer).
D. Align holes on top of Guide with holes in the Nuts on Mounting Block, as shown below.
Using the two flathead screws to secure Guide to the Nuts on Mounting Block.
Tip: If Guide is difficult to reposition (slide), after the two flathead screws are tightened, this is an
indication that the Nuts are not sitting inside the cut-outs on the underside of the Guide. See step
“B” above. Loosen screws and reposition Nuts so they fit into the cut-outs.
E. Tighten Knob (thumb screw) to secure position of Rear Media Support Guide/Sled Assembly.
Tip: It may be helpful to use an
Adjustable Wrench, to hold the Nut
from spinning, when removing these
two screws.
To Next Page
Loading...
