SECTION 3
OPERATING PRINTER
82
Using Layout Tab Printing Adjustments
Top Adjustment moves image vertically (-4.98mm up to +200.02mm down) from top (leading edge)
of media. (0.1mm increments)
Left Adjustment moves image horizontally (+200.02mm right).
Purge Bar Position* – In operation, Printhead spits a small amount of ink into gap between pieces to
keep nozzles refreshed (hydrated). For irregular-shaped pieces (like the open envelope flap, shown
above) sensor may “read” bottom of form early, causing purge bar to be sprayed (printed) onto flap.
This feature allows you to adjust the purge bar position (in 0.1mm increments) to account for extra
distance needed to reach actual gap between pieces.
Tip: To determine Purge Bar Position value, measure the distance from the purge bar (black line
printed on flap) to the trailing edge of the media (end of flap) and add 3mm.
* See also “Purge Bar Position” in Printer Toolbox section.
Max Page Width – Sets width of actual print area. (+0.50mm to 222.75mm in 0.1mm increments).
Can be used to cut-off unwanted data or data that may be printed off right side of media.
NOTE: Setting a value lower than 222.75mm reduces the maximum print width of the printhead.
To Next Page
Loading...
