CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-24
6. Configure IP addresses in Domain Controller Server
Address1, Domain Controller Server Address2 &
Domain Controller Server Address3.
7. Click Save to save the entered settings and return to
Active Directory Settings Page.
8. Click Cancel to cancel the entry and return to Active
Directory Settings Page.
To add a Role Group
9. In the Active Directory Settings Page, select a blank row
and click Add Role Group to open the Add Role group
Page as shown in the screenshot below.
Figure 4-17. Add Role group Page
10.In the Role Group Name field, enter the name that identi-
fies the role group in the Active Directory.
11. In the Role Group Domain field, enter the domain where
the role group is located.
12.In the Role Group Privilege field, enter the level of privi-
lege to assign to this role group.
13.Click Add to save the new role group and return to the
Role Group List.
14.Click Cancel to cancel the settings and return to the Role
Group List.
To modify a Role Group
15.In the Advanced Directory Settings Page, select the row
that you wish to modify and click Modify Role Group.
16.Make the necessary changes and click Save.
To delete a Role Group
17.In the Advanced Directory Settings Page, select the row
that you wish to delete and click Delete Role Group.
IP address of Active Directory server: At least one Domain Con-
troller Server Address must be configured.
IP Address made of 4 numbers separated by dots as in
"xxx.xxx.xxx.xxx".
Each number ranges from 0 to 255.
First number must not be 0.
Domain Controller Server Addresses will supports IPv4 Address
format and IPv6 Address format.
To Next Page
Loading...