QUANTA STRATOS S210 Series S210-X22RQ

To Next Page

To Previous Page

INSTALLING HARDWARE REMOVING A SAS 6GB MEZZANINE CARD

2-40

8. Remove the four (4) screws from the module support

plate.

Figure 2-59. 6G Module Screws and Support Plate

9. Remove the module from the support plate.

Main Page

Table of Contents2
Important Safety Instructions19
Introduction24
- System Features24
- Package Contents27
HDD System28
- System Front Features30
- HDD System Front Features30
- HDD System Front Features31
- Front Control Panel32
- System Rear View34
A Tour of the System28
Safety Measures37
Removing a 2.5" Hard Drive38
Hard Drives38
Installing a 2.5" Hard Drive39
Installing a 2.5" Hard Drive into a Hard Drive Tray39
Removing a 3.5" Hard Drive40
Installing a 3.5" Hard Drive into a Hard Drive Tray41
Power Supply Unit42
- Removing a Power Supply Unit42
- Installing a Power Supply Unit43
Top Cover44
- Removing the Top Cover44
  - Replacing the Top Cover45
Fan Modules46
- Removing a Fan Module46
- Installing Fan Assembly47
Processor Heat Sinks48
- Removing a Heat Sink48
- Installing a Heat Sink49
Processors50
- Removing a Processor50
- Installing a Processor52
Memory Modules54
- General Guidelines54
- Removing a Memory Module54
- Installing a Memory Module55
- Memory Population Rules56
Mainboard Module59
- Removing a Mainboard Module59
- Installing a Mainboard Module60
Expansion Cards (Optional)62
- Installing a Riser Assembly62
- Removing the Pcie Expansion Card63
Mezzanine Card65
- Installing a LAN Mezzanine Card65
- Removing a LAN Mezzanine Card67
- Installing a SAS 6G Mezzanine Card69
- Removing a SAS 6Gb Mezzanine Card73
Intelligent Battery Backup Unit77
- Installing an Ibbu77
- Removing an Ibbu78
Air Duct80
- Removing the Air Duct80
- Installing the Air Duct80
Solid State Disks81
- Removing a Solid State Disk Cage81
- Installing a Solid State Disk Cage82
BIOS Setup Utility84
- Operation84
- Setup Page84
- Entering BIOS Setup85
- Keyboard Commands85
- Menu Selection Bar87
- Server Platform Setup Utility Screens87
- Main Screen88
- Advanced Screen89
- Chipset Screen115
- Server Management Screen122
- Boot Option Screen128
- Security Screen132
- Exit Screen136
- Loading BIOS Defaults138
BIOS Update Utility139
- Recovery Mode140
- Recovery Flow140
Server Management142
- Console Redirection142
- PXE BIOS Support143
- Checkpoints143
Server Management Software153
- Server System Overview153
- BMC Key Features and Functions153
- Power System153
- Front Panel User Interface153
- LAN Interface155
  - Session and User155
- Serial over LAN155
- Time Sync155
- Sel155
- Platform Event156
  - Platform Event Filter156
- BMC Firmware Update156
  - DOS Recovery Utility156
  - Webui Update156
BMC Recovery157
- Recovery Process in DOS System157
- Recovery Process in Linux System157
Quanta Smash158
- System Level Commands159
- BMC Information163
Web Graphical User Interface (GUI) for ESMS164
- Using the Web GUI164
- Login164
- Dashboard165
- Server Information167
- FRU Information168
- Configuration Group174
- Remote Control206
- Maintenance Group214
- Log out216
- User Privilege217
Mainboard Jumpers and Connectors218
- Mainboard Connectors220
- Mainboard Jumpers221
Rail Kit Assembly223
- Installing the Rack Brackets224
Troubleshooting228
- Server Boot Issue Topics229
- Guidelines234
  - Safety Information238
Server Safety Information239
- Safety Warnings and Cautions239
- Intended Application Uses240
- Site Selection240
- Equipment Handling Practices241
- Power and Electrical Warnings241
  - Power Cord Warnings242
- System Access Warnings242
- Rack Mount Warnings243
- Electrostatic Discharge (ESD)244
- Other Hazards245
Product Regulatory Compliance Markings248
Product Regulatory Compliance249
Electromagnetic Compatibility Notices250
- FCC Verification Statement (USA)250
- Europe (CE Declaration of Conformity)250
- VCCI (Japan)251
- BSMI (Taiwan)251
- KCC (Korea)251
- Regulated Specified Components251

QUANTA STRATOS S210 Series S210-X22RQ - Page 76

Table of Contents