672 Appendix C Error Messages
2748 Analog video signal type not supported
The generator hardware configuration does not support the video format’s analog video
type selection.
2760 Digital video not supported
The generator hardware configuration does not support the video format’s digital video
type selection.
2761 Digital video signal swing out of range
The value specified for the digital video signal swing is out of range.
2762 Digital video swing calibration out of range
The value specified for the digital video swing calibration is out of range.
2763 Invalid XVSI
The value specified for the interface selection (XVSI) is invalid.
2800 Pseudo-random noise seed value exceeds limit
The seed value for the pseudo-random noise analysis exceeds its maximum value.
2801 Pseudo-random noise sequence exceeds limit
The length of the pseudo-random noise sequence exeeds maximum value.
2802 Pseudo-random noise type is not supported
The pseudo-random noise type is not supported.
2803 No signal input to analyzer or TMDS error
There is no signal input to the receive interface of the analyzer.
2804 X coordinate for delta patch out-of-range
The value specified for the X coordinate of the delta patch test is out-of-range.
2805 Y coordinate for delta patch out-of-range
The value specified for the Y coordinate of the delta patch test is out-of-range.
2806 Patch height must be greater than one
The patch height specified for a delta error test must be greater than one.
To Next Page
Loading...
