142 Chapter 4 Networking 882s
3. Copy the contents of the 882 folder to the FTP site folder. The resulting folder structure
is shown below.
Removing current files from the 882s
Prior to upgrading the 882s, you must remove the existing system and firmware file,
gateware, and resource files from the flash memory of each 882. For instructions on
removing files from the 882, see “Upgrading the generator locally” on page 97. If you are
also installing the new files on the 882’s PC card, you must also remove the current files
from the PC card.
Copying the new files to each 882
Now you are ready to copy the new, updated system and firmware, gateware, and library
resource files to the 882s to complete the upgrade. See “Working with the 882 FTP
Browser” on page 23 for instructions.
Reboot the 882s
The upgrade is now complete and you are ready to reboot the 882s from the updated
system files you just copied to each 882’s flash memory. Reboot each 882 by cycling the
power.
To Next Page
Loading...
Need help?
General
