152 Chapter 5 Working with Formats
Viewing the source list of formats
You can view the list of formats available in the generator using the front panel or the
command line interface. Use the following procedures to view the Source (format) list.
Note: The Source list of formats that appears on the generator’s display is determined by
the format path. In addition, the list may be filtered based on the interface selected and the
format catalogs that are enabled. For more information about setting the path, see “Setting
the 882’s path” on page 17. For more information about format catalogs, see “Format
catalogs” on page 199.
To view the formats in the Source list using the front panel:
Press the Source key. The list of formats appears on the generator’s display as shown
below. To see all of the formats, press the + and - keys to scroll through the list.
To view the formats in the Source list using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See “Establishing a terminal session with
the 882” on page 30 or “Establishing a Telnet session with the 882” on page 33.
2. Set the path to the format folder on the medium you want to view using the following
command:
FMTP /tffs0/Library/Formats // sets format path to flashmen directory
3. List the contents of the format folder by entering the following command:
FMTQ? 1 200 // lists the formats from 1 through 200
*DMT0660 DMT0672
DMT0675 DMT0685
DMT0785H DMT0856
DMT0860 DMT0872
To Next Page
Loading...
Need help?
General
