194 Appendix A Command Reference
Commands by category
System
Control
Parameters
Command Description
BOIT Initialize generator (without performing self-calibration)
BOOT Restart generator (without performing self-calibration)
SCAL Calibrate generator (using self-calibration circuitry)
UI:MODE Set generator operating mode (Basic or Browse)
NERR? Get number of errors in error queue
ERRY? Retrieve most recent error from error queue
ERRC Clear all errors in error queue
OERR? Check for error queue overflow
NOTU Disables ongoing command execution until communication is
complete
TOGG Enable/disable hot plug setting of source format list via EDID function
INIT Restore generator RAM storage to factory default condition
DATE Sets generator system date
TIME Sets generator system time
Command Description
FRGB Temporarily set image foreground RGB colors
MODE Set serial port communications parameters
To Next Page
Loading...
