196 Appendix A Command Reference
GPIB (IEEE-488.2 standard)
Commands
Port control
Gating Controls
Command Description
*CLS Clear event status register
*ESE Set event status enable register value
*ESR? Get event status register value
*IDN? Get equipment identification string
*OPC Set OPC bit in event status register
*RST Reset generator to known condition
*SRE Set service request enable register value
*STB Get status byte register value
GPIB Set GPIB port address
Command Description
*DDT Execute command on generator when triggered
*TRG Execute/trigger command on generator
*TST Perform self-text on generator
*WAI Wait for command completion before sending prompt
SEOS Set how generator reads strings
Command Description
BLUG Enable/disable blue video output
GRNG Enable/disable green video output
REDG Enable/disable red video output
HPBG Enable/disable reading hot plug formats
OUTG Enable/disable all video and sync outputs
SVSG Set output colors
XVSG Enable/disable output colors