Quantum Data 881 User Manual

882 Video Test Instrument User Guide (Rev A.35) 243
2. Enter the following commands:
SEQL seqname // loads the sequence into sequence edit buffer
SMOD 1 // where 1=step&stop; 2=step&wrap; 3=auto
SEQU // starts running the sequence
The generator’s display shows the format and image name for each step, the mode,
and the current step number. Additionally, the sync gate status and output status
appear on the right, and the color gate status appears on the left, as shown below:
If the sequence is set to auto, it begins running. Otherwise, press the + and - keys to
move through the sequence steps.
To stop a sequence:
Enter the following command:
SMOD 0
SEQU
To run a sequence at power up:
1. Run the sequence in the desired mode.
2. Cycle the power to the generator. Depending on the selected mode, the sequence will
start automatically, or you can press the + and - keys to step through the sequence.
+Red myseq ACS
+Grn Step:00001 DCS
+Blu DMT0660 DSS*
Inv SMPTE133 Out+

Quantum Data 881 Specifications

General

Brand	Quantum Data
Model	881
Category	Portable Generator
Language	English