576 Appendix A Command Reference
XACR
Audio Clock Recovery Data
Class Parameters (Audio Signal and Timing)
Description Sets the N value, and optionally sets the CTS value.
The XACR command takes effect (the new N and CTS values are encoded and
transmitted to the receiver) after the packet is gated on (DPTG command) and the
hardware has been updated (DPGU command).
Command syntax XACR n cts
n
value of audio clock regeneration
cts
Cycle Time Stamp. If not specified, the hardware will calculate the CTS value.
Related Commands DPTG, DPGU
To Next Page
Loading...
