- 47 -
The balance enables cooperation with „SCALE EDITOR” computer software.
Balance window in the software comprises the same crucial information on
weighing as balance’s display. The software enables uncomplicated way of
balance configuration, e.g. printouts customization, main parameters and
RS232 parameters edition. For detailed description of balance-software
cooperation go to „Help…” bookmark.
21. COMMUNICATION PROTOCOL
21.1. General Information
A. A character based communication protocol balance-terminal is designed
for establishing communication between a RADWAG balance and a
peripheral device via RS-232C interface.
B. The protocol consists of commands sent from a peripheral device to the
balance and responses from the balance.
C. Responses are sent from the balance each time a command is received.
D. Commands, forming the communication protocol, enable obtaining data
on balance status and facilitate influencing balance operation, e.g.:
acquiring measurement results from the balance, monitoring the display,
etc.
21.2. List of Commands
Command Command overview
Z
Zero balance
T
Tare balance
OT
Give tare value
UT
Set tare
S
Send stable measurement result in basic measuring unit
SI
Immediately send measurement result in basic measuring unit
SU
Send stable measurement result in current measuring unit
SUI
Immediately send measurement result in current measuring unit
C1
Switch on continuous transmission in basic measuring unit
C0
Switch off continuous transmission in basic measuring unit
CU1
Switch on continuous transmission in current measuring unit
CU0
Switch off continuous transmission in current measuring unit
K1
Lock balance keypad
To Next Page
Loading...
Need help?
General
