- 9 -
6.3. Battery Status
An internal battery comes standard with the balance. pictogram, displayed
at the top of the display, signals battery status.
Pictogram operation Overview
No pictogram Battery full. Standard balance operation
Pictogram displayed
continuously
Battery status low (message <bat Lo> is displayed and the
balance turns off). Charge the battery immediately.
Pictogram blinks every 1s
Battery charging. Balance connected to power supplier, the
battery is being charged.
Pictogram blinks every 0,5s Battery error. Battery damaged.
6.4. Battery Power
• Simultaneously press and keys .
• Message <bAtt> is displayed for 1s. Next, battery power given in [%] is
displayed for 2 s.
• Wait for the home screen to be displayed.
7. MAINTENANCE ACTIVITIES
Disassembly a weighing pan and other detachable components (the
components differ depending on a balance type – see: UNPACKING AND
INSTALLATION).
Caution:
Cleaning anti-draft chamber while still installed may cause damage of the
measuring system.
7.1. Cleaning ABS components
To clean dry surfaces and avoid smutching use clean non-colouring cloths
made of cellulose or cotton. You can use a solution of water and detergent
(soap, dishwashing detergent, glass cleaner). Gently rub the cleaned surface
and let it dry. Repeat cleaning process if needed.
In the case when contamination is hard to remove, e.g. adhesive, rubber, resin,
polyurethane foam residues etc., you can use a special cleaning agents based
on a mixture of aliphatic hydrocarbons that do not dissolve plastics. Before
using the cleanser for all surfaces we recommend carrying out tests. Do not
use products containing abrasive substances.
To Next Page
Loading...
Need help?
General
