- 39 -
• In order to continue totalizing process press key. ZERO indication
and „P” pictogram are displayed. The balance is ready for next totalizing
process.
• In order to finish totalizing process, press
, or key. „P”
pictogram is displayed in the left part of the display. The balance is ready
for next totalizing process.
17.9.3. Function disabling:
• Press key, the following window is displayed:
• Prior leaving <Add> option, you can print out mass values of single
loads and total sum of the totalizing process using printer connected to
the balance (press
key to print and key to cancel printing).
• Message <ESC?> is displayed,
• In order to return to the weighing mode, press
key,
• In order to return to the totalizing mode, press
key.
Caution:
In case of exceeding display range of totalized mass on balance's display,
message <5-FULL> is displayed. In such case, unload the weighing pan and
press
key to finish totalizing process and print out total sum using printer
connected to the balance. Load the weighing pan with smaller mass that does
not exceed display range of totalized mass.
17.10. Animal Weighing
Procedure:
• Enter <AnLS> submenu,
• For 1s message <tinnE> is displayed. Next, window for setting duration
(in seconds) of animal weighing is displayed:
To Next Page
Loading...
Need help?
General
