- 8 -
5. UNPACKING AND INSTALLATION
A. Take the device out of the
packaging,
B. Place the balance on a flat and even
surface. Keep it far away from any
sources of heat,
C. Install the weighing pan in
accordance with the figure below:
6. START-UP
6.1. Levelling
Prior first use level the balance. To level the platform
use the levelling feet and the level indicator. Keep
turning the feet until the air bubble takes central
position.
6.2. Powering the Device
Caution:
Balance can be connected to the mains only with a power adapter that comes
standard with the particular model. Nominal power supply of the power adapter
(specified on the power adapter data plate) has to be compatible to the power
from the mains.
Plug the balance to the mains – connect the power adapter to the socket, next
connect its connector to port located at the back of the balance housing.
Turn the balance on or off using key.
Test of the display unit takes place right after connecting the balance to the
power, all the elements and pictograms are backlit for a short time. Next, the
name and the program number appear, the indication gets to ZERO (displayed
reading unit depends on the balance). If the indication is different than zero,
press
key.
To Next Page
Loading...
Need help?
General
