Radwin 5000 - The RADWIN Manager Log-On Concept

RADWIN5000ConfigurationGuide Release4.9.17 2‐3
TheRADWINManagerLog‐onConcept RADWINManagerOverview
3. OpentheRADWINManagerfromthedesktopicon,orclick
Start|Progr ams|RADWINManager|RADWINManager.
TheLog‐ondialogboxappears.
Figure2‐2:Log‐onwindow‐IPv4
Figure2‐3:Log‐onwindow‐IPv6
2.4TheRADWINManagerLog‐onConcept
RADWIN5000supportsSNMPv1andSNMPv3eitherseparatelyortogether.Thelog‐on
procedurediffersslightlybetweenoperationunderSNMPv1andSNMPv3.Inwhatfollows
below,weassumethatSNMPv1isinuse.InTable 2‐2atendofthesection,weshowthe
differencebetweenSNMPv1andSNMPv3atlog‐ontime.
TheRADWINManagerprovidesthreelevelsofaccessinoneoftwoentrymodes.Tosee
them,clickOptionsatanytimeintheLogonwindow(Figure 2‐2above).Youareofferedan
extendedlog‐onwindow: