Radwin 5000

RADWIN5000ConfigurationGuide Release4.9.17 8‐4
FullRestore Backup,Restore,andUpgrade
Categoriesrestoredareasfollows:
• SystemConfiguration(see4.2.2System)
• TrapDestination(see4.2.6Management)(forSNMPv1only)
• Protocol(see4.2.6Management)
• Date&Time(see4.2.9DateandTime)
• QoSConfiguration(see4.2.10Ethernet)
• HSUConnectionTable(see4.3HSUConnectionTable)
• HSURegistration(restoresthelistofHSUs,andregistersthem)
• ServiceCategories(see4.2.12RADIUS)
7. Oncethesystemconfigurationhasbeenrestored,amessagewi ll appearinforming
youthattherestorationwascompletedsuccessfully,andthatyoumustresetthe
site.
8. Restoreotherconfigurationitemsthatrequiremanualrestoration..
8.5FullRestore
AFullRestoreincludesallconfigurationpar ameters(asshowninStep6.above),inadditionto
systemsoftware.
AFullRestorecanbecarriedoutoneitherthesameHBS/HSUunitfromwhichabackupwas
carriedout,oronadifferentHBS/HSUunit.IfdoingaFullRestoreonadifferentHBSunit,the
hardwareversionmustbethesameasthatofthebackupHBSunit(toseethehardware
version,chooseConfiguration‐>Inventory.Formoredetails,seeInventoryonpage 4‐20).
1. MakesuretheHBS/HSUisdeactivatedbeforestartingaConfigurationRestore.
Categoriesnotlisted(suchasVLANdefinition,HubSiteSynchronization,Antenna
configuration,etc.)mustbere‐configuredmanually.
IfyoumistakenlyactivatedtheHBS/HSUatStep3,de‐activateitbychoosing
Configuration‐>Operations‐>RestoreDefaults ,andcontinuewiththerestof
thesteps.
Donotde‐activateitbyusingtheDeactivateoption.