Radwin 5000 - Configure; System; Radio

RADWIN5000ConfigurationGuide Release4.9.17 5‐5
Configure SUPRO/AIRConfiguration
5.5Configure
5.5.1System
Setthefollowingparametershere:
• Nameofunit
• Locationofunit
• Contactperson
• IPaddressfortheNTPserver
• OffsetfromGreenwichMeanTimeinminutes.
Whenyouhavesetthevalues,clickApplyAll.
5.5.2Radio
Thisoptionshowstheantennatype(dualorsingle),connectiontype(integratedorexternal),
systemTxpowerindbm,andEIRP.
Setthefollowingparametershere:
•SectorID:Enterthesectoridentificationfortheradio.Makesureitisthesameasthat
setintheHBS.
•RequiredTxpowerperradio:En
terthevalueindBm
•ExternalAntenna:Selectyesifyouareusinganexternal,non‐integratedantenna
(ifyouareusingtheTurbo‐Gainantenna,thisoptionisgreyedout)
• AntennaGain(ifusinganexternal,non‐integratedantenna):EnterthevalueindBi
•CableLoss:(ifusinganexternal,non‐integratedantenna):EnterthevalueindB
•ChannelBandwidth:ChoosetheappropriatevalueorAuto
•Frequency:ThevalueappearingwillbeaccordingtoBandandChannelBandwidth
•Band:Setthebandinwhichtheradiowillwork.Fromthepull‐downmenu,selectthe
band,thenclickChangeBand.ClickOKtoco
nfirm.
Onceyouhavesettheappropriatevalues,clickApplyAll.
TheNTPserverusesUDPport123.Ifafirewallisconfiguredbetweentheradio
unitandtheNTPServerthisportmustbeopened.
Itcantakeupto8minutesfortheNTPtosynchronizetheradio’ sdateandtime.
Theonlyexternal,non‐integratedantennasapprovedbyregulatoryauthorities
areflat,withagainofnomorethan22dBi.