Radwin 5000

RADWIN5000ConfigurationGuide Release4.9.17 10‐6
EnablingVoIPfromanHBS QualityofService
10.5.1EnablingVoIPfromanHBS
1. FromtheHBSmanager,chooseConfiguration‐>Ethernettab,thenclickQoS
Configuration.

2. ClickVoiceOverIP.TheRealTimequeuewill changetoVoiceoverIPandits
checkboxwillbecomegrayed.ThismeansthatVoIPtrafficistreatedinasimilar 
fashiontoRealTimetraffic.VoIPworkswhetheryouareusingVLANorDiffServ.
3. YoucanapplyVoIPtoalloftheHSUsinthesectorbyclickingonEnableforall
HSUs.Youwillbeaskedtoconfirmyourchoice.
• Ifyoudonotchoosethis,youmustgotoeachHSUforwhichyouwanttoenablea
VoIPqueue,andenableitthere.
4. ClickApply,orOK.
Makesurethe“Mode”selectedistheproperone,isconsistentthroughyou
configuration,andthatyourend‐userhasequipmentthatalsodefinesitsVoIP
trafficwiththeModeyoudefinedhere.