Radwin 5000 - Deregistering an HSU; Where Has My HSU Gone; Saving the HBS Settings for Reuse as a Template; Creating Nomadic Entries for a Sector from a HBS Template

RADWIN5000ConfigurationGuide Release4.9.17 3‐30
DeregisteringanHSU InstallingaSector
3.12DeregisteringanHSU
AHSUmaybederegisteredbyusingtheDeregisterentryinanHSUcontextmenuorusingthe
buttonfromanHSUbuttonbar.
3.13WherehasmyHSUgone?
SupposethatyouinstalledtwocollocatedHBSswithcontiguoussectors.Itispossiblethatan
HSUlocatedclosetothecommonsectorboundarymay“discover”thewrongHBS.AHSUcan
be“forced”acrosstoanotherHBSbychangingitsSectorIDtothatoftherequiredHBS.The
methodfordoingthisiscoveredinChapter6.
3.14SavingtheHBSSettingsforReuseasa
Template
RefertoFigure 3‐6ofwhichthefollowingisanexcerpt:
Followinganyfurtherfinetuning,openuptheHBSNomadictab,andclickSave.Youare
offeredthestandardSaveFiledialog.SavetheHBSNomadicsettingsfile
(MobilitySettings.mob)toaconvenientlocation.Forourexamplewechangedthefilename
toNomadicSettings.mob.
3.15CreatingNomadicEntriesforaSector
fromaHBSTemplate
Thesavedsettingsfilemaybeusedasatemplateforfurthersectors.
 TocreateasectorfromaHBSNomadicsettingsfile:
1. StartingwithanewHBSandHSUs,logontotheHBS.
IfRADIUSisenabled,itsregisterstatusdefinitionwilltakeprecedence(seethe
RegisterAvailabilityparameterinthe usersfile),unlessyouenable
InstallConfirmationRequired.